Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷
I’ll have to give that camera connection a second look lol
Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷
I’ll have to give that camera connection a second look lol
I just picked up a pi4 b today and was tinkering with octoprint.
So far it looks great, i just haven’t figured out how to get the pi camera module 3 working quite yet. The stream from octoprint just constantly tries to load.
I’m excited to try some prints with it soon!
No, that’s a new one.
Would greasing my gantry screw help?
If I’m missing steps due to heat is the only solution a new motherboard?
I thought so too! I cleaned it up a bit and glued the bottom back on. Its my pencil cup at work now
I have! This printer actually finished a 3ft sailboat rudder before this print. I popped some pictures of it in as well
Do you think that could be be solved by adjusting the z offset?
Thanks for the tip! I’ve been hesitant to start messing around to much but I think it should if it means it’s more reliable
I’ve been looking at this for a while. The camera I have on it is a security camera that i put on my desk while it prints if I’m gone.
Do you think its worth pulling the trigger on a raspberry pie to get this set up?
It would at least once lol
Yes, I just finished printing a rudder core for my sailboat.
For all the headache its caused, its also saved me from several trips to the store to find cable ties, chip clips, a hair dryer holder, pencil cups, spice racks, etc.
Sweet thank you!
How’s Freecad these days? I avoided awhile ago it because it looked difficult to use but I think this might push me over to it
I have a Espon ET-5150. Its worked fine so far but I wish my wife would’ve let me spring for a laser printer.
Thank you for the tip! I’ll look into those for sure. It sounds like they would be a perfect fit with very little downside
Hahaha I’m good there! I’m on month 2 of what should’ve been a 3 day project for a friend. I’m chalking it up to a bad model after this and moving on to a different print to save my sanity
Thank you! I gave it a clean and fingers crossed it works put tomorrow when I’ve got some more time to mess with a test print
Thank you! Unfortunately i didnt get a cool spaghetti monster this time, but I like the idea of keeping them to see how far youve come
Thank you! I that makes me feel better about leaving it print while I’m at work
Thank you! I’d rather deal with a contaminated print than a fire
That’s fair. More accurately a different reputable brand. Prusa and Bamboo Labs are both ones I would look at if I had to do it all over again.
Thank you, i’ll do some digging!